In a few simple steps to a superb print
Published on September 28, 2024.
Below, read the instructions on how to apply our decals on t-shirts, but the same applies to other products such as hoods, bags, umbrellas and other promotional products.
1. Cut
Unpack your transfers and cut out the designs with scissors.
2. Heat the press
Heat the heat press to 150°C, set the timer for 10 seconds.
3. Position
Position the print in the desired location. Lower the press.
4. Peel
Lift the press and immediately peel off your decal.
5. Done!
The transfer is fixed on the T-shirt.
Advice
It is not possible to use too much pressure on the heat press. In principle - the stronger the pressure - the better the print.
Advice
For best results and a softer feel, turn the transfer paper over and press the imager for another 5 seconds.
Advice
Before applying the imager on the t-shirt, pre-press the t-shirt for a few seconds to get rid of moisture.
What can DTF transfers be applied to?
DTF (Direct-to-Film) transfers can be applied to various substrates and materials. Here are the most common:
Textile
- Cotton
- Polyester
- Cotton and polyester blends
- Nylon
- spandex (elastin)
- Twill and canvas
- Denim
Apparel
- Shirts
- Sweatshirts and hoodies
- Hats
- Jackets
- Shorts and long pants
- Sports equipment
- Work clothes
Other products
- Bags and backpacks
- Textile face masks
- Scarves and hair bands
- Umbrellas
- Pillow cases
- Bedding
- Curtains and curtains
- Tablecloths
How to properly store DTF transfers for long-term use
DTF transfers are extremely sensitive to storage conditions, especially moisture. If the transparencies sit in the air and absorb moisture, this may affect the quality of the final transfer, as traces of moisture may appear during pressing. In order to avoid such problems, it is important to properly store the transfers. Below are recommendations on how to your transfers.
Store in a dry place
DTF transfers should be kept in a room with a low level of humidity, ideally in hermetically sealed bags or containers. Investing in a moisture control system, such as silica gel bags, can further help protect the imager.
Avoid exposure to air
If the transfers are left outside for a long time, there is a greater risk of them absorbing moisture from the air. It is recommended to return the transfers to their protective packaging immediately after use.
Optimal temperature
Keep the transfers at room temperature, away from heat sources or extreme cold, as such conditions can also affect their quality.
What to do if the transfers get moist:
If the transfers have absorbed moisture, traces of moisture may remain during the first pressing. In this case, you can press them again using: baking paper, greaseproof paper or Teflon sheet.
This additional pressing will help remove excess moisture and restore the smooth appearance of the print. By storing properly and using these techniques, you ensure that your DTF transfers maintain optimal quality and durability even after long periods of storage.
Order Premium DTF transfers online at the best price
Price list of DTF transfers (58cm width)
1 meter
1m - 10m
10 meters and more
Online DTF designer
For beginners
For beginners or those without design software, the DTFprint.hr online DTF Gangsheet designer is the perfect solution. With a user-friendly interface and a range of customization tools, creating DTF transfers has never been easier.
Open online designer
Upload your PDF
Experienced users
Upload one or more pdf print ready files, enter dimensions and order DTF transfers for textile products with automatic price calculation depending on the ordered length. More meters – more savings!
Upload your PDF
